This tutorial is set by the author's setting without permission.

Foreword: This tutorial uses a integrated package nomifactory.

Not recommended this production line!During the MV stage, you can use light fuel plus steam to crack to obtain steam cracking light fuel to make ethylene.(But because the distilled tower cannot be used, the oil utilization rate cannot be mentioned the highest)

Polyethylene is one of the important materials in the MV stage. Its more complicated production lines may make Mengxin discouraged, but if it is rational, it is not difficult to mass -produced polyethylene.

This is the synthetic table of polyethylene -produced polyethylene tablets

This is a synthetic table for ethylene to exacerbate the reaction

During the MV stage, we can use ethanol to take off a molecular water to produce ethylene in concentrated sulfuric acid, so the ethylene line is split into ethanol lines and sulfuric acid lines

flow chart

Below is the production line

The first is the compressor to compress the plant into plant balls. Be sure to open the items automatically!In this tutorial, if there is no special explanation, the default machine output faces the next machine

This figure is the ethanol line. From left to right, the compressor, the brewing room (the blue below is infinite water), the distilled room.

The following is the sulfuric acid line, the output direction of the machine: from right to left

The machine where the grass block is placed in the middle is a machine that produces ethylene. From the beginning to the right is chemical reactor, chemical reactor, electrolytic machine, quantum cylinder (stored hydrogen), and the oxygen of the electrolytic machine is transmitted to the chemical reactor through the electric pump.Hydrogen is transmitted to the quantum cylinder through the electric pump.Put the sulfur in the box, and the chemical reactor behind the box placed the robotic arm on the surface of the box, and adjust it to the input mode. This can produce sulfur dioxide., Pass to the chemical reactor marked by the grass block, synthesize ethylene

The dilute sulfuric acid generated by the synthetic ethylene is transmitted into the distilled chamber to recycle it into sulfuric acid, then returned to the chemical reactor, and then the synthetic ethylene is passed into the previous chemical reactor, and the air collector is placed next to it.Enter the chemical reactor, so that polyethylene can be produced in the chemical reactor.

Put the fluid curing machine in front, and automatically output it into the drawer next to it.

As for the extra hydrogen.EssenceEssence

You can perform oil desulfurization operations during HV, so that hydrogen sulfide produced by desulfurization can be used for sulfuric acid production, and you do not need to manually add sulfur powder.