Tutorial start

First look at the finished picture I made by myself

The first is the most basic AE kit includes: controller, drive, synthetic panel, model panel, storage component, synthetic memory (CPU)

The second is that the ME interface is used to transmit items, a panel -shaped ME interface and square ME interface

Then use the catheter (here the item catheter using EIO) from the ME interface to absorb items to the injecting devices (leave a piece of the core). This tutorial uses the EIO item catheter to adjust the panelYou can inject the device, not here to repeat it; of course, the catheter of other items is also possible

Pay attention to the empty hand SHIFT+right -click Set the injection device as a single item mode

Then there is a model tutorial

The material on the left can be queried and costs. The number must not be wrong

At this time, the synthetic delivery has been basically completed

It is normal for items to be delivered to the representative system, but at this time, it will be found that the synthesis of AE has been stuck in. Each time you must manually click to cancel it.

So we need a system to complete this operation, and the following is a solution

A self -loop small structure!A self -loop of an input bus and an output bus (two locations can be interchanged, can be placed wherever you can). After we send instructions, as long as the item returns the AE network, it is deemed to be completed.Situation problem.

The following is the UI configuration

Note here that the mode must be changed to a cycle mode. The model inside puts the synthetic blocks at all levels that we renamed. If the capacity is not enough, I will add one

I am worried that the speed of returning the network is not fast enough, so I added a acceleration card

Next, we can connect this small structure to the AE network.

Next, we only need to click synthesized in AE

2. Put in the equipment (I made a cycle here for him to put the product back to the top, we can continue to operate on AE continuously, no longer come here to re -put the clothes from below)

3. Then put the core required for the promotion in our empty position (the core will not be consumed, so it can be upgraded to the same item all the time)

You can automatically start the aggregation by the redstone bell (redstone bell can also be replaced by other items that can send redstone signals, the purpose is to automatically start aggregation)

Under the skillful use, put the equipment and core first, and click the first level to wait for me to complete, then click the second level, and then the third -level synthesis (foundation, flying dragon, Shenlong)

Video teaching

https://www.bilibili.com/video/bv12p411w7gv/?vd_source=cfcce1a11a749F1193445F13FA769