This tutorial is set by the author to use the CC By-NC-SA protocol.

Brief introduction

A simple and practical small module for automatic split crystal stones.

It is only necessary to use the original block to build it. It is suitable for lack of modules with logistics capabilities, or when the cost of making a logistics system is relatively high.

Module volume: standard version 5 × 4 × 4, stacking version 4 × 4 × 4 (minimum unit volume).

Why is it semi -automatic?

Only the original and Xinghui cannot realize the automatic collection and placement of the star energy liquid, so this module only includes the cycle and collection of crystal stones, and the module of the transportation star liquid needs to be designed separately.

In the case of pure original version, you can only use a transmitter to half automatically placed the star energy liquid, but if there are tools that can transmit and place fluids in the bucket that can be transmitted and placed in the bucket, you can use other modules.Realize the fully automatic (subsequent "application example" chapters, some specific solutions are given).

Construction method

Basic structure

123 The reinforward delay in the direction of the throw device is delayed at the top of the top, and the rest are 1 transmitter facing the water block, which contains a barrel 45A5B

The transmitter represents a tool for placing the fluid

Rising edge trigger decline edge triggers

The transportation part is used for transport and separation of crystal stones.The bottom omn -to -bottom is used for output, and its direction can be adjusted as actual situation.

The timing section is used to control the activation order of funnel and throws.

The detection part contains a T trigger that is used to detect the consumption and placement of the star liquid.

Siege the position of the star energy liquid, you can place tools that can place fluids in it.

According to the working principle of the fluid placement tool, select the appropriate trigger method:

5A should be selected when the transmitter, etc.

5B should be selected when the fluid placement tool stopped when receiving the redstone signal.

Place the star energy liquid above the funnel, and then put a crystal stone or celestial crystal stones in the star energy liquid to start running.

After starting to run, it is recommended to cover the top of the star energy liquid, otherwise the throwr will have a small probability to throw the crystal stones to the star energy liquid.

Variant 1: viscosity piston

You can use a viscous piston instead of the launcher as the T trigger:

In this solution, the red stone fire can be placed in another position to replace the transmitter to a viscous piston

Variety 2: Packing version

On the basis of the adhesive piston version, some changes to prevent mutual interference can be made, and you can stack it in the direction of the three coordinate axis:

The main part modifies the rising edge trigger, and there is no need to change the decline edge trigger.

Knowing problems of stacking version:

If it is stacked in the direction of the three coordinate axes at the same time, it can only be input and output by pipes and other methods;

Because the location of the star energy liquid is completely closed, it may be difficult to investigate and repair if the failure (such as the crystal stones is collected).

It is not recommended, after all, there is not much space saved, and Xinghui's demand for crystal stones is not high, and several units can be fully satisfied.

Working principle

The state of T trigger (transmitter or viscosity piston) can indicate whether the star energy liquid has been consumed.

When the star energy liquid is consumed, the funnel ① locks, and the crystal stones are pumped into the thrower.

After supplementing the star energy liquid, the funnel ① lock, the thrower ①, ② activate in order, and put a crystal stones into the star energy liquid; finally the funnel ② unlocked the lock and pump away the other chinetite that may exist.

You can output the produced crystal stone to other containers with tools such as connecting boxes, or using pipes and other tools.

Because the probability of the two split crystal stones is equal to the star liquid, it is not recommended to use this module to purify the crystal stone.

Application example

Semi -automatic example

When the logistics equipment is extremely lacking (such as only the original and Xinghui), you can use the funnel to pass the star's liquid barrel into the transmitter, so that the device is semi -automatically run.

A box of star energy barrels can run for about half an hour.When the star energy liquid barrel is exhausted, the device will stop running. After reloading, you need to press the reset button to restart.

The back of the air bucket funnel classifier below the launcher

Using this scheme requires a lot of barrels, but if a module can extract the star energy from the polycons or curb the sanctuary and load it into the barrel, it can save the barrel and fully automatically automatically.

Full automatic example

If there is a module that can transport and place fluids, it can be fully automatic.

Taking a practical fluid molding device as an example, the fluid can be placed when it is not activated by redstone.The reason why red stone control is because the speed of placing the fluid is too fast in normal conditions, which will cause the detector to output only one pulse once, and the red stone cannot be reset.

The steps are not necessary, just to avoid being blocked by the thrower below

This device does not require manual reset. As long as the star energy liquid in the fluid molder is sufficient, the device will start immediately.If you want to close, just provide a continuous redstone signal to the fluid.

Note: The star energy liquid is a low -temperature fluid and cannot be transported by the TE's restraint of fluid pipelines.