This tutorial is set by the author to use the CC By-NC-SA protocol.

All versions of this tutorial

I believe everyone has found many tutorials and tutorial videos.

When the tutorial talks about how to work with a steam driver, it will say that it is necessary to return to the boiler from the steam engine or steam turbine.

It's like that.

The reason is only a description of the steam engine and steam turbine.

It will discharge 80%of the steam into four output ports on the side.(This sentence is particularly important)

The following is an amazing fact:

If you boil ordinary water to drive the boiler to work, the collected distilled water will not return to the boiler.

The collected distilled water will accumulate in the pipeline. After reaching the capacity of the pipeline, the other three ports on the side of the steam engine (steam turbine) are discharged into the air.

In other words, all the distilled water we burned was wasted.

Why?

The pipelines on the side will indeed collect distilled water, but because the system judges that distilled water and ordinary water are not a thing and will not let them fusion.

So, everyone.

If you are afraid of waste in the early stages of burning boilers, save the distilled water generated by a barrel.

If you are not afraid of waste, you don't need to take it back to the flow pipe.

See Tips for the method of using this technique (6)