The correct launch method of the steam engine:

1. Put in water, as little as possible, but not less than 100MB.It is recommended to use a bucket of water 1000MB or a general mechanical basic storage tank for 300MB at a time.

2. All fuel tanks are full and start heating.

3. Staring at various data, when the pressure value rises to 150 or the temperature is too high, the water is not evaporated enough, and the water is added immediately, the more the better.

You can see that the pressure value is full instantly.

If you believe your technology, you can fill the pressure value and add water to cool down

4. Driving a motorcycle

Tip: If the temperature is too high, the locomotive will be fried, but it will generally not, because the temperature will generally evaporate before the temperature exceeds the standard.

After the boiler is not water, it will be kept at a low temperature.

True anti -human boiler

The correct launch method of the internal combustion engine:

1. Come on, the oil volume is determined.

2. Start the engine and make the braking full.Be sure to start the engine. After starting the engine, it will consume fuel and consumes very slowly.If you want to save fuel, you can also grow temperature without startup, but the slower the later, the slower, and the last stop.Don't ask me how I know

3. Press the throwing valve to increase key, you will find that the higher the temperature, the smaller the stream valve limit, the faster the temperature rises.

4. After the temperature meets the standard, let go of the brakes and gallop!

In general in half a minute, internal combustion engines can be started.

Tip: If the temperature is too high, the locomotive will turn off. If you need to open the stream valve when climbing, you will be stretched and turned off the engine when the temperature is too high.Light at 90 ° C and set up a brake.

In this method, the startup of steam engines is faster than internal combustion engines.

But is the power of the internal combustion engine not fragrant?