The first part: the construction of the pipeline

Two types are divided into two types: object pipes and fluid pipes, but the construction of pipelines is exactly the same.This takes the copper flow pipeline as an example. When a pipe is placed, it is placed in uninterrupted.As shown in the figure

We need to use a wrench to connect. When the square of the pipe is aimed at, Jiugongge will appear. Click Jiugongge to connect the corresponding direction.As shown in the figure

As shown in the figure, I only ordered the above and right of Jiugongge. You can see that the pipeline connects the upper connection and connects the pipeline on the right.At the same time, you can see that the connected direction is in Jiugongge with × click again, and the connection is disconnected.

When holding Shift with a wrench right button, there will be something like an iron ring, which means that this fluid or item can only be produced from this and cannot be in.

Part 2: Item Pipeline

1: Pipeline parameters

As shown in the figure, there are two parameters of the item pipelines, which are transmission efficiency, and priority

I can't figure out the transmission efficiency (mainly in terms of time). My understanding is the largest transmission volume.

2: The path of the item in the pipeline

First consider the most basic situation, and use only one item pipeline. At this time, the transmission of items is the shortest path

As shown in the figure, it can be seen that only the shortest path in the middle is received.

When the item pipe is not output, the items will not enter the pipeline.

But this is not enough for us to use it, we can modify any point in the path

3: The use of filter board

There are three types of filter plates, namely items filtering, mineral filtering, and advanced items filtering

Placement of filter board:

Similarly, holding a filter board to the item pipeline, you can see the Jiugongge, the same method of connecting the same pipe, put the filter plate, use a screwdriver to open the filter panel, use a crowbar to remove the filter board

The easiest items filter

You can see that there is a biggest button above, with three modes, which are filter input, filter output, and filtering.The understanding of filter input and filtering output is that entering this pipe is input, and the pipe out of this pipe is output.But if the filter input or filter output, it cannot be output or input.There are three buttons below. It is basically easy to understand.The nine plaids on the left are the items that need to be filtered.

The difference between mineral filtration and advanced items filtering and items is basically different. The actual test can basically understand it, and it will not be explained for the time being.

4: Priority

When the same pipeline is the smallest, it is actually simplified calculation. The actual calculation process is the minimum diameter of the pipeline priority on the path.

The priority of the nickel items pipeline is relatively high compared to the preferential priority of the alloy, resulting in the flow of the items to the right

Part III: fluid pipeline

This is a very late fluid pipeline. It can be found that its entry is much more than the item pipeline. The transmission rate is the amount of transmission of the transmission.

The temperature limit indicates that the pipeline can transmit the maximum temperature of the fluid. If the fluid temperature is higher than the upper limit of the pipeline temperature, the pipeline will be burned.

It can be transmitted that the pipeline can transmit these things. If it does not indicate that the pipeline transmits these dangerous fluids, it will be destroyed.

The fluid pipeline has the characteristics of reflux, but you can right -click to suppress the return of the return through the wrench of the first part.The filtering of fluid pipes is basically the same as the filtering of the item pipeline.