1.12.2 IE and IC2 do not link, and energy cannot be converted without other MOD assistance.
Many people say that they can use Mek. I think there are MEK.I don’t need to pack a dumpling restaurant for this vinegar star
Therefore, the purpose of this article is to propose several energy conversion of IE and IC2 without adding the main type of MOD as much as possible without adding the main type MOD relationship.
1: Industrial Cable: Converting Industrial Wires
It must be this version, not [IW] Industrial Wires (this version can not be directly converted, and any cable will directly explode with two MOD electrical appliances and power.But trouble not to mention, the loss rate is as high as 46%)
It is designed for the conversion of two energy.
The conversion rate is about 1EU: 4FLUX, slightly losing
Two diesel engines are output 2048EU/T, but I didn’t expect that it was better than diesel
Note: This MOD's connector can cache a small part of the power. Like immersed wirers, although Waila and engineer's meter will not display, if it is temporary conversion, do not look at one end and hurry to remove it. It is best to wait for another otherThe power at one end stops to increase and then do it (of course, if you don’t care about that point, there is no problem)
2. Energy Converters
The advantage dedicated to the energy bridge is that the cost is not expensive while ensuring different rate requirements
It is slightly cumbersome to use, you can refer to this tutorial
Simple Tutorial of Energy Conversion -Energy Converters -MC Encyclopedia | The largest MINECRAFT Chinese MOD Encyclopedia (MCMOD.CN)
Warning: UHV output (IC2) (IV Energy Producer (IC2)) may have the risk of blowing MFSU
3: [GC] Aluminum Wire
GC's aluminum wire is used to convert it very well. One wire can be connected to the two MOD batteries on the ground.
The conversion rate is about 1EU: 4flux, but slightly tall
When IC2 → IE conversion, there is no difference between the two aluminum lines, and the transmission speed depends only on the maximum output power of the power storage box itself
Unable to use MFSU output to the capacitor of IE, it will directly explode (but can connect countless MFE)
When conversion of IE → IC2, the rate of heavy aluminum lines is twice the aluminum line
The disadvantage is that the rate is not good.IC2 → IE cannot use the high pressure of MFSU. Compared with the energy bridge connection at → IC2, IE → IC2 This is a small water pipe. The heavy aluminum line rate is only between MV and HV
Although the galaxy itself is a main MOD, the scientific and technological composition is not high, and the relationship between the inter -MOD has little impact.
4: [WD] Subspace Capacitor of Warpdrive
As a cache intermediary
If you can't take away, dig off the power will be empty
You can change the input and output state, which is exactly the same as immersion, that is, the hammer is replaced by the sound fork
Right -click to view the RF input/output rate of the capacitor
EU output rate: 128EU/TEU output rate: 512EU/T
EU output rate: 2048eu/T
Compared with the synthesis above, it is not particularly convenient (the need for the tears of evil souls to brew the regenerative potion, of course, there is an immersive mixture (Mixer), each drop of tears can be a bottle of bottle, a drop of one excerpts of one excellent child space capacitor)
But the rate is good, only one excellent child space capacitor can ensure that the electricity of the two diesel generators is exported all out of EU
白板状态下电阻是非常大的，此处输出仅为1889EU/t（每台输出为944EU/t，以上方其它方式导出时每台均为约1024EU/t，也就是说损耗率高达0.08，略Lost), you need to install superconductor plug -in to reduce the loss of resistance
This sub -space is tolerant
If there are other recommended methods, you are welcome to recommend
