This tutorial is set by the author's setting without permission.

The existing tutorial is not very friendly to Mengxin, so I have this [Fast Society to build a MEK nuclear clustering reactor tutorial]

MEK nuclear concentration reactor uses 氘 and 氚 to generate electricity.

Get 加: Use the filtering and upgraded electric pump to draw heavy water, and then the heavy water input an electrolytic separator to obtain 氘 and oxygen.Remember to right -click to open the electrolytic separator interface settings to discharge excess.

Pay attention to the output products of the electrolytic separator, do not lose the oxygen as a cricket.2. Get 氚: Build two distilled towers, give one of the input water to turn the water into saline, and enter the next distilled tower through the mechanical pipeline to turn salt water into liquid lithium.

For mechanical pipes used to extract salt water and lithium, the right -click pipe port of the adjusttor Shift should be changed to the extraction mode to pull out the salt water.

For details of the construction of the distillation tower, please refer to the thermal distillation tower.

It is recommended to use wood heater to heat the thermal distillation tower.

In the later period, a resistor heating device can be used instead of the wood heating machine. The RF consumption setting of the resistor heating device is 33333 to make the 18 -layer distilled tower efficient.

The thermal distillation valve on the side of the No. 2 tower is connected to the mechanical pipeline to access the rotary gas liquid converter. The liquid lithium uses a rotary gas liquid converter to become a gaseous lithium.Turned to 氚.3. Get the black body radiation cavity: the 氘 and 氚 input chemical irrigation device is obtained to obtain 氘氚 fuel, and the black body radiation cavity is placed in it for irrigation.

4. Build a reactor and enter the 造 and 氚, and put it in the black body radiation cavity.

For the construction of the reactor for details, please refer to the fusion reactor.

After the construction, the response rate is adjusted to 2. If the fuel can continue to increase, the higher the rate, the faster the power generation.

5. Build laser arrays.

The laser will shoot out in front of the front, and the laser traction beam is used to change the laser direction, so that it will converge into the laser amplifier.

The redstone control of the laser amplifier is high, so that the calories can be stored.

1.12.2 Store to 400m, 1.7.10 to 1g, and then control the redstone control to low. The laser amplifier will shoot all the storage heat into the reactor to run the reactor.

The above data is the minimum requirements for turning on the reactor. If your reactor is not opened, it is recommended to store more.

Finally, the lit reactor will have animations in it.

At this time, the reserved interface that transmits RF is adjusted by the adjustor as the output mode, and you can use the cable to guide the electricity from the response.

The interface of the output mode is like this. The adjustment device selects the energy mode and dives the right -click interface.Nuclear agglomeration can also be added with fuel. Power generation is faster. The use of the use of fuel to add 氘氚 fuel to the MEK fusion reactor to improve power generation

If you feel well written, click "Recommend" below to support me ~