For unknown reasons, all Microblocks cannot use NEI to view the synthetic method in my integrated package. I explored how to synthesize these blocks for a long time.Share the method now, so as to prepare the inquiries of the person you need

Tool: Any hand saw

Machining method: raw materials and hand saw synthesis, orderly synthesis, hand saw is durable

(Note: The two same parts that are cut free can be combined into the previous squares in the workpan, disorderly synthesis)

(Note: No blocks with GUI can be found to participate in this type of synthesis)

Processing table:

Step 1: Block ↓ level

Place a square under the orderly synthetic hand saw to cut into two steps of the same material

Step 2 branch A: step ↓ panel

Place a step under the orderly synthetic hand saw to cut into two panels of the same material

Step 2 branch B: step → pillar

Subtilial hand saw a step on the right side can be cut into two pillars of the same material

Since then, every time A processing is performed, the material will become thinner (steps → panel → cover) or thinner (steps → pillar → pillar → strip), and each time B processing is performed, the material will become shorter (steps of steps (steps of steps↓ Pillar ↓ incision, panel ↓ pillar ↓ horn, cover plate ↓ strip ↓ one -eighth angle).The logic is that each time A processing is equivalent to a vertical dissection of the material, so it is processed vertically; each time B processing is equivalent to a horizontal section of the material, so it is processed horizontally.

Finally, eight steps/panels/covers can synthesize the corresponding hollow components in a lap in the 3x3 work.