The tempered furnace of this module is strange and requires time

Although you can use some other module timers such as

Here I leave everyone a number of water words

However, this module comes with a 20T chronograph, which can be used simply.

This is this, pretty cheap

It looks like this after opening

The first two are the number and time interval of the pulse.

This one is two ticks

So you can simply make such a device.

Note that behind the pulse generator must be a straight red stone line to enter the redstone signal

So leave an extra redstone as in the icon circle.

Next reading

The saw blade is 73tick, so 36.5 gear is required, and the sum of the gear gears in the figure can be adjusted to 37.

Of course, because there is a 5Tick error, 38 gear is also possible. This is fine -tuning according to the actual play.

Since I used 3, it is, [20] [16] [1] (Note that the minimum is a gear)

Of course, you can also adjust 20,9.9 and the like, as long as the total is 37 or 38.

Same

Gear 66tick, requires 33 gears, all gears are 33-35

Drilling 89tick, 44.5 gear, all gears and 44-46 can be

The blade 54tick requires 27 gear, all gears are 27

The last one is to attach durability to the weapon tools. 116tick is 58 gear, but my actual test is 43.Everyone fine -tune this according to the actual situation.

There is also a durable armor for armor, but it takes 61 gear (that is, 4). It seems that the 60th gear is also okay, but the probability of success seems to be relatively low in experiment.

All the above data is the test data of my archive. Pay attention to fine -tuning according to the actual situation when used.