Because the characteristics of the red stone lamp are added to the new version, the old tutorial is repaired to better read

First apply the overall structure diagram:

There are high versions of AE and blood magic here.

Taking the model supply as the input terminal, the ME interface as the output terminal (only to distinguish)

Then divide the structure into a single film for explanation

Part 1: Structure display

Taking the green line as the input terminal, the red line as the detection end, the blue line is the output end, the storage bus with the wooden barrel is

The red line is used as the detection end to detect whether there are any synthetic items in the altar.

Here is the details of the combination. The detection part and the upper output part of each unit need to be disconnected separately, and the second half of the recovery part needs to be connected.

Part 2: Tag details

Green line: The storage bus of the altar is marked with slate material, and the priority is set to the storage bus larger than the wooden barrel.And the storage bus storage bus labeling the filter of the wooden barrel

Red Line: The standard trigger sets the redstone signal when it is greater than or equal to 1 item

Blue Line: Storage bus marking with the ME interface is tested by filtering items for the corresponding product mark

Enter the end -end model interface or ME interface: Open the blocking mode in the upper right corner to prevent multiple slate task filtering items entering multiple columns of wooden barrels (cache box) at the same time

Part III: Structural Federation Explanation

Here we set the filtering items to be gold ingots and diamonds, and the products of synthetic slate are blank slate, enhanced slate, irrigation slate, demon slate, and hanging slate

If it is not filtered, it will cause it. When you need to synthesize and enhance the slate, enter the blank slate, but the blank white slate is also one of the products, which is used as a product output

So the solution of this tutorial is to divide the 1, 3, and 5 items into one category, and the 2 and 4 into the second category

And: blank white slate, irrigation slate, and hanging slate use gold ingots as detection filtering, while strengthening diamonds and diamonds for enhanced slate and demon slate as filtering detection

At this time, when the gold ingot is used as a detection item as a material input, because there is no gold ingot, it will not be drawn as a product, but because of the diamond, the product will be pumped after synthesis

Part 4: Details of Model Labels

Here we use blank white slate as an example to explain

As mentioned above, although the blank white slate is added to the gold ingot as the detection material, although the stones can be filtered, only a demonstration here

In the same way, add gold ingots to the formula of irrigation slate and hanging slate, and add diamonds to the formula of strengthening the slate and demons to distinguish

The number of synthetic objects and products here is not limited, and only one of the filtration items can be

Part 5: Run Logic Explanation

Here

1. The blank slate and diamonds are entered into the synthetic network. Because of the filtration and priority, the blank white slate enters the altar first, activate the sender below, and turn off the diamond recycling line, so that the diamond will not be pulled back into the cache container will not be pulled back.AE

2. After the diamond enters the cache container, open the line that uses diamond as a synthetic filtering item to open the channels for reinforcement and enhanced slate and demon slate as the product of the product.The product of items will not be identified as the product

3. After the synthetic strengthening slate, because the identification as the product causes the input bus back to AE, there is no items in the altar at this time.

Knowing that Blood Magic can be directly attacked by dimensions after the teste of redstone, now the rewrite tutorial is considered to provide some players with demand.