This tutorial is set by the author's setting without permission.

Preparation materials

Place the orbit of the elevator floor on the floor.Use a brush to change the floor number and add the description you want

Floor editing UI interface

After editing the floor, you can use the elevator to create an elevator

At this time, you will find that the elevator is overlapped with the track. Then right -click the track and you can turn on the elevator debugging interface

Here, you can debug all kinds of things, including the offset of the elevator, size, double door, and elevator facing

It is like this after adjusting

Next, it is the installation of the elevator door and the elevator button

When the elevator door is placed, facing the elevator, you can place this elevator door in the original MTR in the original MTR, you can use a brush to use it normally

The elevator button, just find a place you like.Use a button connector to bind it with the elevator track.

If you want to install the display, the steps are the same as the installation elevator button.

Each layer repeats such a step, your elevator has achieved great success

Press the Z key to open the GUI selected by the floor. After pressing the floor, the elevator will be closed.You can select the "Ding" sound on the floor settings interface, and it will sound after reaching the floor.

The following is the elevator I installed in our city building