Place a controller, a disk drive (storage disk storage disk), fluid terminal and fluid panel.Build a simple RS network.Use general machinery electric pumps and mechanical pipelines to connect the extracted magma to the fluid panel.As a result, it is stored in the disk (opening the fluid terminal to see that the magma inventory is always rising, it means that the operation is correct).If the electric pump shows that there is no fluid, move a grid down and let it be wrapped by the magma.If you do n’t work, you can change a few more positions to put the pump, which is a bit metaphysics.

The speed of the electric pump is upgraded by the speed of MEK and the speed upgrade of the fluid panel with RS can greatly accelerate the speed.The power supply method is selected from the energy cube of MEK, it is best to be an elite or ultimate energy cube.

When the fluid is stored, the fluid storage disk can be taken away and returned to the main world.Build the same RS network in the Lord World, without flowing the panel.Insert the fluid storage disk filled with magma into the network.And place items to store disk (that is, ordinary disks) to store the obsidian produced.

Next, you can start producing obsidian.Use the cable to extend a distance from the controller and set up the following structure.

A bucket of water was placed on the far right.On the left is the molding panel.Switch to the fluid mode and place a bucket of magma up, displaying the following plate as soon as possible.At this time, the magma will be automatically released and the water flow is touched by the right side to form obsidian

Next, place the destruction panel placed on the quasi -obsidian. After the obsidian is destroyed, check the synthetic terminal of the RS network, and you can see that obsidian is constantly increasing.Note that there are two disks in this network, one is a disk filled with magma from the hell RS network, and an ordinary storage disk (one itself).Otherwise, obsidian will not be destroyed, because there is no item storage disk, which will cause the obsidian drops after destroying obsidian cannot be input to the RS network, which will be crashed.

If you want to control the production of obsidian and input the output to the main network, you can operate as follows.First, place a tie rod on the controller of obsidian production network, and open the controller. Click the redstone mode in the upper left corner to select- "Work with redstone signals".

Then prepare a box and output panel (set a white list and put a obsidian up to click), and output the stored obsidian into this box.

It is confirmed that the obsidian in the network is continuously exported to the box.Put the input panel on the other side of the box and extend to another network through the cable.You can realize the transfer of obsidian to other networks.You need to pull the obsidian production line when you produce.

According to the calculation of a 4.2K magma, it can produce about 4,200 obsidian, which is basically sufficient to produce.In addition, MEK's pump pumping magma lake seems to be the entire lake surface of the bottom of the bottom block, which is basically infinite magma.At the same time, the destruction panel and the molding panel can be upgraded at the speed, which can significantly improve obsidian production.