This tutorial is set by the author's setting without permission.
As we all know, MEK's five -fold mineral processing line is a performance of a MEK graduation. Create a stable five -fold mineral processing line is the ultimate pursuit of players!I explored and experimented on the basis of the previous five -fold mineral processing line, and finally established the five -fold mineral processing line described in this tutorial.
The front row reminder: This tutorial mainly uses two mainstream modules: MEK and thermal force, but only MEK's processing line can be built!Use thermal 5 to be more convenient!
Let's first understand the modules of this processing line.
Main processing module
Sulfuric acid production module
Hydrogen chloride production module
Hydrogen recycling processing module
Of course, it is not blowing stable and low consumption, above!
This power consumption is not the power consumption of only one processing line. This is the energy consumption of five processing lines at one time!Although it is not the lowest consumption on the entire network or the most efficient on the entire network, I believe that this is the best big words at present on this site and the most detailed five -fold mineral processing line.The need for processing lines.And overall processing lines are not complicated, I will use as short as possible to teach you how to build this processing line.After completing the tutorial, I will also analyze the consumables and efficiency of the entire processing line, help the survival parties who want to establish a processing line as soon as possible, and the players who are more convenient to compare other processing lines horizontally.
Let's start the tutorial section
First build a distilled tower used to produce salt water. The nine layers of each tower are high. On the right side of the second layer of the first tower is a valve.
The second tower is the same as the first one, except that it is symmetrically separated by three grids.
Third, the same is true of the four towers, but it is changed to five grids and then symmetrical.
Pump!Nine high distillation tower efficiency is 150MB/T, so the three full -speed electric pumps are almost enough.The speed -layer fluid pipeline of the pipeline with heat 5 is because the transmission rate is unlimited and there is no cache, which will not affect the water supply but it will be more expensive.
Then there is the resistance heating device. Setting 1000rf/T is enough.
After that, there are three electrolytors, left sodium and right chlorine, do not reverse, remember to set the default discharge and excessive discharge chlorine
Arrange the output of the distilled tower.I do n’t know why the output of this version of the thermal distillation tower cannot be configured. I have to export it with the server of the Heat 5.
Place chemical irrigation, arrange gas pipelines and wires, and leave electricity, hydrogen and hydrogen chloride three pipes.
The same is true of the remaining No. 3 and No. 4 tower. Pay attention to the direction of the output of the electrolytic output.Only the overall wiring diagram here.Finally, put a gas storage tank to start the cache, remember to excrete excess.
In this way, we have done the part of the production of hydrogen chloride.
I originally wanted to finish the remaining part, but I found that this space was a bit too long, so I had to disassemble it to the upper and lower parts and release it.But it doesn't matter, I will make up as soon as possible these days, see the next!
