This tutorial is set by the author's setting without permission.

First of all, you need to find mineral grains (if you are nickel or graphite, you can directly use the survey pick on the ground)

After finding the ore grain, the position of all kinds of ore grain around the surrounding campaign is marked, and the central point of the distribution of the mineral particles is found.

It is recommended to use the torch marking position. The cost is low and the light source is a light source. Opening the night mode using the travel map can easily find the center

If you do n’t install a travel map, you can easily find the center point with a few grids such as wooden boards.

After finding the center point, dig out vertically at the center point. Pay attention to digging 1*2 mineral channels. Do not dig directly at the square under your feet.

It is recommended to prepare enough fresh water, food and support pillars before starting to dig

Freshwater is generally 2-3 bottles.

The support pillar is about 8 groups, but I usually bring 4 groups of original wood and a saw, and now saw it

If you plan to explore the mine and dig a backpack home, it is recommended to bring 2-3 vases, otherwise the grid is basically not enough

When digging down, every 3 grid is tapped with a mine pick up, and the first time there is a huge amount, the top is explorated by the top, until the content of the content changes from a large amount to a huge amount, and write down the height, and then continue to continueDigger down until you find out a large amount to a lot of positions

If the results of the exploration pick when the exploration pick is found from a trace/medium/large amount/huge amount to "No special", it is usually a false alarm. It is recommended to explorate several other blocks of the same height until normal until normal.Results so far (the results of the same block of the same block will not change)

After finding the two edge positions (a large amount of a large amount and a huge amount to a large amount), take two height intermediate values. At this height, starting horizontally, just like the previous vertical mining, find two edge positions, butIt is recommended to explore once every 4 grids to facilitate the calculation distance

A support beam is required every 4 grids during horizontal excavation to avoid the landslide

After the two edges are found, continue to take the middle point, and then dig at the middle point to the side (if you dig the X axis before, dig into the Z axis, vice versa)

The method is consistent with the previous digging to the side, and I won't go into details. The middle point that is finally found is the center of the mine pulse.

If you have not seen ore at this time, dig out from the center of the mine to the outside

Note: Just see the ore directly dig down the ore at any time. The purpose of finding the center of the mine is to find the ore.

After finding the ore, digging along the ore, similar to the original open -type mineral channel, but don’t forget to put the support beam

Dig the ore of the same layer when mining, ignore the top and bottom, otherwise the mineral channel will become chaotic and it is difficult to walk

When the ore of the same layer is basically dug, start digging the top layer of the top layer (the same as the same layer as the horizontal support pillar), and then the ore upward will not be digged. It is easy to collapse.It collapsed completely

Do not dig the top above the top of the ore above, so as not to be smashed by gravel

When the ore on the top of the top is almost dug, you can start digging the ore below, but don't dig directly below, it is easy to fall to death.

The mine below is more convenient than the horizontal digging. Don't put the support beam, but don't dig horizontally to ensure that you only dig from the top of the block to avoid collapse