This tutorial is set by the author to use the CC By-NC-SA protocol.
This automation is designed for an integrated package of an MCBBS-ETM
Source page: http://129.211.167.41/index.php/%E7%94%E6%88%B7: dethE7%83%AC%E6%89%B9%E9%8F%E7%82%BC%E9%87%E5%8d%8a%E87%AA%E5%8a%A8%E5%E5%E5%E5%E5%8C%96-ETM
As we all know, Yu Ember's alchemy is very troublesome
Because in ETM, there is no easy -to -use logistics module, and the pipeline of Yu Ember itself is very garbage. Therefore, the original functions of this automation use the original funnel and the redstone circuit to manufacture automation.
Method:
Put a filling item of the number of formulas in the two funnels near the center, and put a filling item in the two funnels next to the two funnels, that is, the number of items in the two funnels and the number of formulas +1, and then right, right, right?Just throw an item activation device with the void sucking device.
ETM's large amount of resources at this stage are two symbols that this tutorial will be automated by two bases. After grasping the principle, it is not difficult to expand.
Fully filler device:
Fill in the ashes through the funnel to the base. The funnel is locked by the red stone fire handle below. Under normal circumstances, there will be no filler. The redstone fire handle controls the activation time from the rear funnel timer, so as to control the amount of ashes filled in.
There are two devices, and both sides are symmetrical.
Please make sure that the amount of ashes in the container above the container is sufficient
Dominatal chronograph:
Through the funnel timer, the number of ashes is controlled by the foundation. Because the number of funnel transmission items is the same (one item is every 8tick), the ashes corresponding to the number of formulas in the amount of formula can be set in the funnel of the funnel.
The funnel timer is locked by the RS lock in the rear. When the RS locks are switched, the funnel on the left is no longer activated, the funnel timer starts timing, after the timing is completed, the red stone fire handle on the right lit up, and activate the rear behind the rear.Confirm the device after filling, and switch the RS memory mode.
Due to the inevitable reasons, the funnel on the left will remain in one item. Other items are in the funnel on the right. The number of items in the right funny fight represents the number of ashes set.
There are two devices, and both sides are symmetrical.
The power transmission speed of the funnel is 2.5 items per second (one item every 8tick). The funnel is not transmitted after the energy is charged. The comparator can detect the number of items in the container.
To detect whether the funnel contains items in the comparator, control the state of the viscosity piston. When all the items in the funnel are transmitted to another funnel, the comparator stops activating.At the same time, the sticky piston on the other side extends to prevent red stones from being pushed back.
The red stone is full of funnels and locks the funnel. This funnel will not transmit items into another funnel, so as to pass the time. When the items in another funnel are transmitted, the red stone is replaced, the status is reset, and the cycle reciprocates.
RS locks:
The RS memory has two states that can be switched to each other.
The two states of the RS locks here are lock timers and unlocking timers, and the unlocking timer starts to fill the ashes.
Synthetic completion of the inspection device switches the lock state to unlocking state. When the funnel timer completes the timer, the unlocking state is switched back to the lock state.
There are two devices, and both sides are symmetrical.
Due to the unknown reason, when the timer completes the timing, the short -pulse generated by the redstone fire can not switch the RS locks mode.
Therefore, a relayr was added and it was adjusted to 2 gear (2tick delay). If this method is adopted, one of the items left on the left of the timer will become two items.The number of items should be the number of formula -1.
If other methods are adopted, please ensure that the total number of items in the two funnels in the funnel timer is the number of formulas +1.
Confirmation of the filler:
The main function of the confirmation device of the filler is to ensure that the ashes on both sides are filled and activated the beam gun.
This device uses two throwers -type RS locks and one with the door. The thrower type RS locks are composed of two throws that are faced with each other.The activation of the comparator. When the comparats on both sides are activated at the same time and activate with the door, there are two red stone torches on the side of the center of the center to activate the beam gun and reset the RS memory.
Synthetic completion test:
The alchemy product is absorbed by the void collector to the funnel, and the funnel is transmitted to the box. At the same time, it is detected by the rear comparison.
The role of the relay on the left is to prevent the interference of the redstone powder of the funnel timer. At the same time, the low -intensity pulse of the comparator detects the comparator detection into a high -strength pulse.
The role of the two relayrs on the right side is to prevent the two RS locks from interfere with each other.