Foreword: It is recommended to use the "OD scanner" to dig (scan within the range of 5*5).

Thought:

The position of the fixed diamond is 5*5 (slightly deviated) in front of you (above and below).Then use Pickup to look at each mine (fish bone mining) as much as possible.

Tools required: OD scanner (nonsense), pick (preferably sometimes).

Find steps:

1. Go to y = 11 layer to dig a 2 -square -grid and one -wide mineral channel (arbitrarily in the direction, avoid lava!)

2. Use a scanner for each 5-10 grids

3. Once the diamond appears, it will be scanned at each grid until the signal disappears.

TIPS: If it is displayed as 2 diamonds or 1, then this diamond ore is usually at your feet

4. Take a step forward in the grid where the signal disappears, and put a round stone behind (to mark the position without diamonds, please always remember this position, do not dig this!)

5. Dig 4 grids up, pad 3 stones under the feet, and use the scanner again to observe whether the diamonds are still (the number is reduced = the diamond is below).

6. If the diamond is reduced or disappeared, it indicates that the diamond is at the foot.Step 5 and 6 are just to confirm that diamonds are on our heads or under our feet (there are deviations)

7. Then excavate and dig the stone that is flat on the left (until your hand is not enough).The same is true on the right.

8. If not, continue to dig ahead, dug 3 grids, repeat the seventh step (if you do not have 5-6 times after repeating, return to the origin, increase 3 heights or reduce 3 heights, repeat the dig)

In the end: You can find about 3 layers (the mine channel of the X -axis excavation is set as a layer).

Core ideas: Mainly digging ore in horizontally, digging three grids and digging three grids are to locate diamonds under the feet or top of the head. If the scanner does not scan the diamond, give up the layer directly.

PS: It looks complicated and practical and skilled. It is very brainless. It used to be in 15 minutes and dug a set of diamonds.