This tutorial is set by the author's setting without permission.
The annihilation reactor capacity of ultra -material material has strong power generation capacity. In order to further improve the efficiency of power generation, I wrote this tutorial.
In order to prevent accidents, we need to stabilize the six planes of the gravity abnormal point.
The stabilizer and the abnormalities of the gravity are separated by two squares.
Next set up an annihilation reactor
1. First place an annihilation reactor controller and adjust to a suitable position to make the projection center point an abnormal point of gravity.
2. Place a material decomposer next to the controller, and place mechanical shells in other projection places.
3. Replace the three mechanical shells of the remaining 3 edge centers where the controller is located to the annihilation reactor interface.
Each surface of the annihilation reactor interface and the annihilation reactor controller can output power, and each surface's maximum output is 100mrf/T.Therefore, in order to increase the output rate, we need to extinguish more reactor interfaces and annihilation reactor controller.
Next, the existing reactors are all three in each, all of which are built on the reactor.
Pay attention to the position of the material decomposition machine in the upper and lower layers, and the material decomposer should not be cut on a straight line.
Next, the material decomposer and annihilation reactor controller are powered on each layer, and two speeding upgrades are added to the material decomposer, and fuel is put into fuel.
In the figure below, the ultimate general -purpose cable of MEK is used for power, and other cables can also be used to power on.
At this time, the decomposer breaks down the anti -substances generated by the positive ion state (the unit is KM) and the annihilation reactor generates the reaction to generate energy.
Next, please transmit energy according to your own MOD. The two transmission schemes are given below.
The first is the core and energy tower of the eight -level energy and energy tower in Dragon's Research MOD.
The energy transmission rate of the energy tower can completely keep up with the output of the reactor. The disadvantage is that it cannot use each annihilation reactor interface.
The second is to use the MEK guide matrix
As shown in the figure, all the annihilation reactor interfaces can be used, but the input rate of the input matrix is limited to energy transmission.
Third
Suggestions from the comment area, thermodynamic energy pipelines of thermodynamics and energy tower are used to use the energy core and energy tower of the research of the heating dynamic pipeline and the dragon.
We can also build the reactor on the Z -axis of the center point on the basis of this reactor to wrap this gravity abnormal point to achieve higher efficiency.
