This tutorial is set by the author to use the CC By-NC-SA protocol.

In theory, this principle is still feasible above 1.12.2, but it is only tested in version 1.12.2.

In fact, it is the Langken loop, but MEK has the highest efficiency. In addition, the [NCO] nuclear power process: Nuclearcraft: Overhauled) Langken loop has been well supported.

The heating problem of the salt tower is recommended to use the resistor heater. Anyway, we are not bad, or directly from the reactor

The water consumption is huge, and it can be matched with [WPP] Water Power/FluidSystem (FLUIDSYSTEM)/[PP] Pressure Pipes/[NC] nuclear power process ([NCO] nuclear power process: Remake version (remake version (remembered version (NUCLEARCRAFT: Overhauled) and others can provide a large amount of water MOD.

Because such large industrial chains can cause a lot of stuck, consume a large amount of computing resources, which will cause the fusion pile to stop due to unknown reasons.At this time, you only need to automatically produce the black body radiation cavity, automatically irrigate, then transport it to the reactor, and then use a resistor heater (or multiple) to keep the reactor temperature to achieve the purpose of ignition.MEK's fission pile does not necessarily start with laser start, as long as the temperature meets the ignition conditions.The reactor does not instantly drop the temperature when the reactor is suspended, so a small amount of electricity can consume a small amount of electricity to ignite the reactor.(This is what I saw in a tutorial. As for which one is not found, if anyone finds a message in the comment area)

Based on this type, laser can greatly increase the temperature of the reactor, and even achieve the effect of "laser boiler".

As long as the fuel is not placed, the reactor is equal to a boiler.

The following is an extremely streamlined text explanation version:

Frequent reactors can produce electricity, steam, and calories through water cooling.The heat and water will generate steam when the boiler is received. The steam generated by the reactor and the steam generated by the boiler are transported to the turbine to generate electricity, together with the electricity generated by the reactor as the output.The turbine will produce condensed water and can be reused.

The following is a paragraph of the Langken cycle extracted by Baidu Encyclopedia:

The water is compressed and boosted in the water pump; then enter the boiler to be heated and vaporize until it becomes an overheating steam, enter the turbine to expand and work. After the work, the low -voltage steam enters the condenser and is cooled and condensed into water.Go back to the pump and complete a cycle.