This tutorial is set by the author's setting without permission.
Tree cutting
This is a large jungle tree.
Place a log in front of it.
Place the power saw, and right -click against the original wood, you can facing it.
Place the hand -shaken crank.Turn.
That's OK ~
Early semi -automatic
Faced with a high wall, so you don't have to run far away.
Waterwheels are provided with energy, so you don't need to shake your hand.
The log of logs should be put, and the tree must be made up by themselves.
Personally, I feel very practical.Put a piece of wood, you can cut off a large tree.
Use a sawwood machine to influence the forest
This is a forest.
Find a tree on the periphery, right -click and put on the sawwood and shake the crank.
The lower the wooden machine, the better, and the big tree is added separately.
He used his chain mechanism to use logs to connect all trees.
Turn the crank, the whole world is quiet.
Synthetic mucus ball
The mucus ball is a necessary material for automatic tree field.
The material is a dough+yellow -green dye.There are differences in each version.
The dough is synthesized by the water powder.
Wheat powder is produced by stone mills.
There are many yellow -green dyes.Simple is grinding flowers.
Ultimate tree field
Flat water vehicle
Dig a 3x3 pit, two grids deep, put on soil and waterwheel.
Put water.This is the biggest energy of waterwheels.
Let him turn
Connect the power bearings, the chassis of the case.
Power bearing is used to rotate.
The chassis of the case is used to accommodate various devices. The length is not limited to achieve super large tree fields.
If you are empty -handed and right -click, you will turn or stop.
The speed is still amazing.
The case chassis needs to be set, and the ctrl+rolling wheel is adjusted to 1.
This guarantees that only one square will be sticky before and after.Rather than the log behind the block.
Install various devices
Method of installation: Right -click the mucus ball.Dye this stuff to green
It will not consume mucus balls.
Squatting down and right -click to remove the mucus ball.
There are places where mucus balls can be pasted.
Cut the trees on the front, so the pneumatic saw.(The front when rotating)
Trees are planted on the back and a robotic hand.
The robot filter is set into sapling.
Don't put it at the end, the saw is not enough.
Add a layer of the chassis, and then use the mucus ball to put the box.
Put the sapling into the box.
In a dynamic structure, all mechanical energy access to all containers.
The power saw will put the drop in the container.
The robot can also take the sapling in the vessel.
Put a mobile storage interface in a place to output things to the outside world.
This interface is one -to -one, mouth -to -one -to -be, aperture.
You can connect the brass funnel later, and then set as many transmission.
I am 32 here, if it is less than 32 it will not output.
Product sorting
You can connect to the teleportation belt later.
Change a little longer, add a few more rows.
Coupled with the brass tunnel, the connected brass tunnel is a whole, and the output items of each surface can be set separately.
The five major products of oak:
Finally, the funnel box.
Collect leaf
The saw can't collect the leaves, and my approach is:
This can receive half of the leaves, and the other half is sawn by the saw.
Half of the output is already amazing.
Some optimization
Clean up a two -grid ditch to make people pass and make the machine start or stop it. It is much easier.
Fill the middle open space.
Use a wrench to adjust the bearing mode, only structured in the initial position (becoming a square)
The ditch is also in the initial position.
Change the position of the interface, use strong glue.
The final effect:
